Die CPU müßte doch schnell genug sein
Configuring Stream Relay
Some older receivers support PowerVu only through Stream Relay (internal streaming). This setup needs a fast CPU though and not every STB is fast enough. If you cannot fix stuttering with the following guide, likely your CPU is too slow.
For best performance, the "Include ECM in http streams" setting must be enabled. If your image supports it (openpli, openatv), you can find it in OpenWebif -> Settings -> Customize.
If the setting is not available, you may need to adjust the "ECM fix delay" setting in OSCam webIf (Config -> Stream Relay). Increase/Lower it until there is no stuttering.
Stream Relay needs an modified channel list. Edit your channel list as following:
Go to the OpenWebif and click on the "Stream" button for the channel you want to add.
Download and save the .m3u file.
Open the .m3u file with a text editor and get the stream link. It looks like this: http://stb:8001/1:0:19:0123:3EF:1:C00000:0:0:0:
Replace the port (8001) with the relay port (default: 17999) and the host name ("stb") with 127.0.0.1 http://127.0.0.1:17999/1:0:19:0123:3EF:1:C00000:0:0:0:
Add the new stream link to your channel list (for example with DreamBoxEdit)
IMPORTANT:
Do NOT use the correct Transponder ID/Network ID/Namespace for the stream link.
Use Transponder ID: "11", Network ID: "22" and Namespace: "33".
Set Service Type to "1", and enter the correct Service ID for the channel.
Note:
When using DreamBoxEdit:
A. Go to the list in the middle "Bouquet details".
B. Right click on a channel, select "IPTV and other streaming services", select "Add".
C. Select "DVB/TS".
D. Chosse a name and use the new stream link as URL.
E. Use the "Service ID" of the original channel. You can find it in the left list ("Services")