BPanther's Neutrino Forum

Hmm, strange, here I have a SIG. But I have currently only the single tuner BCM4505 at the DM820. The DM900 has the tripple tuner, test follows...

EDIT: Yes, here the same @DM900 with tripple tuner.

Ok, rebuild again all 5 DM images, rev20771...
Same time, 30-60 min. until all ready.

EDIT: All images done...

Is it original kernel

You don't flash via online/offline update. The *.tar.xz must not be used. Flash the kernel manually as twice described, then you will have the right kernel.

Imageinfo current version, online update used:

Rebuild all images again (rev20772) with small fixes and for DM820/DM7080 with kernel check. If kernel not from the image, a message will tell you this and you have the choices: <Flash> <No flash> <Don't ask again> (until new image flashed).

All images done...

BPanther hat geschrieben: Mi 19. Jun 2024, 18:05 You don't flash via online/offline update. The *.tar.xz must not be used. Flash the kernel manually as twice described, then you will have the right kernel.

Sorry but failed to update online/offline update
When I try to flash online/offline update box restarts and nothing updated is the above process same for dm900 via telnet
Please tell me how to flash kernel Manually in dm900
(flash-rescue zImage-rescue-3.14-r0-dm900-20161208.bin) is it right command to flash via telnet

The online/offline update was one of the first things what i have activated and testet. And I use this here for DM820/DM7080/DM900/DM920 without any problems.

Online update:
If the box really reboots, then you must have the new image version. If the backup fails or other problems, only neutrino will be restartet - no reboot.

At the start of playback, the image remains at this level It is not possible to select from any key on the control unit
Then after a short while it works

Maybe the framebuffer init problem at first boot. I will set a popup before, maybe this helps.

Unpack and replace the file at /usr/bin. Hope this helps.

BPanther hat geschrieben: Do 20. Jun 2024, 12:05 Unpack and replace the file at /usr/bin. Hope this helps.

check-kernel.zip

Same problem the remote control does not respond

Hmm, the event devices now the same as DM7080. Strange, at the tests they was different. New images for DM820/DM7080 build, rev20775.

Please unpack and replace msgbox at /bin. Then should it work...

BPanther hat geschrieben: Do 20. Jun 2024, 12:54 Hmm, the event devices now the same as DM7080. Strange, at the tests they was different. New images for DM820/DM7080 build, rev20775.

Please unpack and replace msgbox at /bin. Then should it work...

msgbox.zip

Now it works 100%
Thank you

If you say "Yes" the kernel will be flashed. Via online update should only display a short message "check kernel version" and then the message disappers because via online update the kernel will be also flashed.