BPanther's Neutrino Forum

Maybe they use other drivers. The last version 24042019 does not working here (hangs at loading), but the Februar version is working and now used. Older versions does have many other problems (no OLED etc.). Strange drivers...

In Openatv 6.3 they are also from 24/04/2019 and the indications are much higher on the same channel, only in the image with E2 the turntable configuration menu is more simple

Correction: The DUO4K has the driver problems with 24042019 - the SOLO4K has the last driver version 24042019. So there should be near the same SIG/SNR.

It seems to me that this is about entering the correct value for the positioner. In E2 there is e.g.
018.787
050.298
And in Neutrino I don't know how to enter it correctly



And in Neutrino I don't know how to enter it correctly, there are too many position items

With "green" you can make the point and with "yellow" you can clear all fields.
Your settings seems to be too high in Neutrino because you forgot the point. I think, this should be right (same as E2).

Thanks, the ordinary user will not know that there are such options, there should be colored keys with marking.
However, after entering the value as in E2, nothing changes.

darog69 hat geschrieben: So 1. Sep 2019, 10:43Thanks, the ordinary user will not know that there are such options, there should be colored keys with marking.

Yellow is most the key to delete the input values. The green key I have found with testing. There is a Wiki for settings etc. (not by me), but only german: https://wiki.tuxbox-neutrino.org/wiki/NeutrinoHD

darog69 hat geschrieben: So 1. Sep 2019, 10:43However, after entering the value as in E2, nothing changes.

Sorry, but I can't test this.

No problem, I'm waiting for Multiboot's further development and for working enigma2-stb-startup_1.00-20190517_all
Maybe I can figure something out

darog69 hat geschrieben: So 1. Sep 2019, 21:56...and for working enigma2-stb-startup_1.00-20190517_all

This works without problems, just a simple boot changer. If anybody can write a better one, please do it. For me ok as it is, I know the images at the partitions, also which was startet.

So you will change without telnet command (reboot -f) to another startup from OATV, because it doesn't change with me?
Designating individual startup_x is not a problem, but switching

As I sayd before, DO NOT USE REBOOT -F ! You may destroy all mounted filesystems! Furthermore, -f (force reboot) is not needed. Do you use the reset button at the PC to restart a working/running system? It's the same...
The partition changing works without any telnet command. A message is shown if a STARTUP_X choosen, how "Umgeschaltet auf < STARTUP_X >" - see the pictures. A normal REBOOT (not RESTART GUI) per menu is enough.

Ok, I understand, it works like you write with the reboot command

Edit: I will exchange what image I have managed to run in Multiboot so far: OATV, OBH-4.3, OHDF, OpenVision-9.1, Hyperion6.4, OpeVix-5.3

I don't understand this, if there is a good signal on the UHD channel, why is it so low on HD?

Here I have some other values:

RTL UHD: SNR 83%, SIG 67%
Kinowelt: SNR 84%, SIG 66%
ZDF HD: SNR 84%, SIG 70%

Here also no problems.

It seems to me that after uploading your channel list under Motor Dreamset2413x64 program